4. Using a break point

A break point allows you to pause execution on a specific line. This is a great tool to see what the state of a program is at a specific point in its execution.

A break point is similar to pausing the program, but you have greater control over exactly where the program is paused. In addition, you can set a break point then reload the program to pause a program you otherwise couldn't with the pause button.

To do this:

  • Bring up the developer tools. Usually this is the F12 key.
  • Switch to the Debugger tab. This is called Sources in Chrome.
  • Locate and open the file from the Navigator. This can then usually be hidden if more room to view the code is needed.
  • Find the line you want to pause on.
  • Click the line number to create or remove a break point.
If the program is executing, it will pause the moment this line is reached. If the program is not executing or is past the line with the break point, you can press the browsers refresh button (unfortunately not the F5 key) to restart the program from the beginning.
If the break point is inside of a loop or a callback, it will pause each time the break point is reached. You can click the resume button to continue execution until the break point is reached again.
You can set as many break points as you like.

The animation below shows a breakpoint being placed at the top of an animation call back. A variable is output to the console to see it's value then resume is clicked to continue execution. After three repetitions, the breakpoint is removed and resume is clicked so the program executes normally.


Tags: